Promax® 300/301 Series gas water heaters are made to provide economical performance that will reduce your energy bills as well as provide long-lasting value.
Featuring a How Much Does A Gallon Of Water Weigh In Ounces tank and 40,000 BTU gas burners, GCV-40 standard ventilation supplies a rating of one hour 70 gallons along with a recovery rate of 41 gallons by the hour. With an Energy Factor of 0.59, this water heater doesn't satisfy the ENERGY STAR® qualification. This has a limited warranty of 6 years, and meets certain requirements of Low NOx emissions.
Many factors influence the actual performance of water heaters. This is the closest estimate of the knowledge about water heaters in Blora, 07, but actual performance may vary depending on factors beyond our power to control or estimate. To see or adjust our assumptions regarding the most typical factors that affect the performance of the product in Blora, 07, please see advanced settings. * Annual energy cost is estimated from the energy efficiency of every water heater, estimates of the household water use & regulating temperature, average groundwater temperature for the location, and housing energy prices as reported from the Department of Energy.
Gas water heaters heat water by burning natural gas or LP (propane).How Much Does A Gallon Of Water Weigh In Ounces need an air source as well as have to be disposed of properly. Cold water enters the water heater through an internal "dip tube" that forces cold water in to the bottom of the tank and pushes domestic hot water out with the outlet connection. This arrangement provides hottest water for the size of the tank provided. Most water heaters use pilot lights. Pilot lights on some models also produce the electricity had to operate electronic gas valves. When cold water enters the tank, the temperature sensor around the gas control tells the principle gas valve to start. Gas flows on the burner where it is lit by pilot light. The air essential for burner comes from the room where the water heater is installed. Exhaust gas is discharged outside. When the right temperature is reached, the principle gas valve will die. Because water can corrode steel tanks, we line the inside of the tank and install an anode rod in lowering corrosion. Temperature and pressure retaining valves are safety devices designed to start when the internal temperature or tank pressure exceeds a specific limit. Water heaters must be sufficient to provide adequate domestic hot water even when the temperature is cold and need for the most important household.